×

Solar Metal probe Vehicle Sensor

Solar Metal Probe Vehicle Sensor

Wireless gate Alert strobe light

Wireless Gate Alert Strobe Light

Base Receiver 4 Zone

This is our 4 zone slave base receiver as supplied with our standard 4 Zone Wireless Gate Alert Kit.

In some cases an additional base receiver may be needed. A slave base receiver (as pictured) can be interfaced with your existing driveway alert providing a dual receiving system.  Perhaps one receiver in the house and another in a shed. The receiver underside delicts a "site code". To enabled a slave base receiver, we require the site code. A Clone base receiver is by order only.

 

$345.00
Availability: In stock
SKU
BaseR

4-Zone Base Receiver
The Wireless Driveway & Gate Alert Four-zone Base Receiver has additional on-board features, whenever any enrolled beam-set beam is interrupted, it sounds an alarm. The alert sound differs depending on the activated Beam-set.

4 zone wireless gate alert receiver

The Four-zone Base Receiver has 4 different selectable tones and volume levels. Other devices (or an alarm panel) can interface with the Base Receiver via a detachable terminal block located on the back of the enclosure or via a GSM connector at the rear. Located next to the terminal block is an aerial connector for two supplied tuned aerials. Use the taller aerial for longer driveways.

A 12V Power Adapter is supplied to power the Four-zone Receiver.  When the beam set/s detects gate or fence motion, a transmission is sent to the receiver. The Base Receiver also receives diagnostic report messages from the installed Beam-set(s), including Low Battery and Beam Blocked alerts. Whenever the Base Receiver receives a communication of any kind from the Beam-Set(s), it responds with an acknowledgment / confirmation signal. Each separate Beam-set activates a different beeping sequence from the Base Receiver so it's easily identified.

If you already have a 4 zone kit but require one or more additional beam sets, see here.

Base Receiver
Maximum Number Of Supported Beam-Sets: 4
Two-way Radio Supervision: YES
On-board Diagnostics: YES
Volume Adjustment Increments: YES – Adjustable Volume (can also be muted)
Power Requirements: 12V DC
Dimensions – Millimetres: W75 | D119 | H30
Warranty: 3 Years

Accessories
1 x Four-zone Base Receiver
1 x 12V Power Adaptor for Base Receiver

 

More Information
By Order No
Write Your Own Review
You're reviewing:Base Receiver 4 Zone
Your Rating